If you have questions, call 800.GE.CARES or visit our website at: www.monogram.comInstallationInstructionsZV95036" Stainless Steel Vent Hood
Pre-TapSideScrewPre-TapSideScrewBracket TabsScrews“B”Screws“A”Installation Instructions10 4 INSTALL THE HOODPlace the hood on the brackets and slide
11Installation Instructions5 CONNECT DUCTWORK • Install ductwork, making connections in direction of airow as illustrated.• Push duct over the exha
Installation Instructions 8 INSTALL FILTERS• Remove protective lm on the lters.• Tip the lter into the slots at the rear of the opening. Lift the
Safety InformationWARNING: TO REDUCE THE RISK OF FIRE, ELECTRICAL SHOCK OR INJURY TO PERSONS, OBSERVE THE FOLLOWING:A. Use this unit only in the manne
Design Information3PRODUCT DIMENSIONS AND CLEARANCESCONTENTSDesign InformationProduct Dimensions and Clearances ...
Design Information4Using Duct Cover AccessoriesA Duct Cover Accessory may be required for your hood installation height. Use this chart to determine i
Installation Preparation5ADVANCE PLANNINGDuctwork Planning• Determine the exact location of the vent hood.• Plan the route for venting exhaust to the
Total Equivalent Quantity Equivalent Duct Piece Dimensions Length* Used Length Round, 1 ft. straight (per foot len
Installation Preparation7TOOLS AND MATERIALS REQUIRED (NOT SUPPLIED)• Tape measure• Knife• Spirit level• Wire cutter/stripper• Wire nuts• Electric dr
• Drill 1/8" Pilot Holes For Mounting Brackets.Centerline8" Min. AboveTop MountingBracket Holes6-1/4"Centerline To WallFOR WALL VENT DU
9 1 INSTALL FRAMING FOR HOOD SUPPORTIMPORTANT: Framing must be capable of supporting 100 lbs.Installation InstructionsIf drywall is pre
Comments to this Manuals